Paints and varnishes – Determination of resistance to liquids – Part 3: Method using an absorbent medium (ISO ); German version. Buy DIN EN ISO PAINTS AND VARNISHES – DETERMINATION OF RESISTANCE TO LIQUIDS – PART 3: METHOD USING AN ABSORBENT. DIN EN ISO Paints and varnishes – Determination of resistance to liquids – Part 3: Method using an absorbent medium (ISO ).
|Published (Last):||18 December 2004|
|PDF File Size:||16.65 Mb|
|ePub File Size:||13.97 Mb|
|Price:||Free* [*Free Regsitration Required]|
Dn body plummet method ISO If the substrate of the test piece is to be examined for visible alterations, remove the coating in conformity with the specified procedure.
Cover the vessel and leave it to stand without stirring. If several test pieces are loaded in the vessel at the same time, make sure that they are spaced at least 5 mm apart or, in the case of highly conductive test liquids, 30 mm apart see 8. The test ISO Field method rn the turbidimetric determination of water-soluble sulfate ISO General principles ISO Preparation grades of previously coated steel substrates after localized removal of previous coatings ISO Standards with isoo titles given in German are either only available in German or may be procured in other languages from the institution issuing the standard.
TL EN ed _图文_百度文库
Particle size analysis by laser diffraction ISO Inclined-plane flow test ISO Olivine sand ISO This second edition cancels and replaces the first edition ISO Determination of moisture ISO Measurement of chloride on steel surfaces prepared sio painting ion detection tube method ISO Press the adhesive tape? One end of a rod shall be rounded, with a radius approximately equal to the radius of the rod.
Method for the calibration of ISO surface profile comparators and for the determination of surface profile – Focusing microscope procedure ISO Determination of water-soluble contaminants by conductivity measurement ISO Determination of contrast ratio of light-coloured paints at a fixed spreading rate ISO dun The 212-3 pieces shall be electrically isolated from their holders.
February Number of pages: Aluminium substrates ISO Ring-and-ball method ISO NOTE 2 Immersion depths other than half-immersion may be used by agreement.
ISO 色漆和清漆 耐液体介质的测定 第1部分：在除水以外的液体中沉浸 – MBA智库文档
Chilled-iron grit ISO First and second coat are of the same color Permissible first coats for all colors: Adhesive residues after removal of the preservative film are not permitted. Discover also Certification, assessment, diagnosis Get a quote for certification of systems, products or services, and get certified.
Goniochromatic paints Automotive fuels – Fatty acid methyl esters FAME djn diesel engines Requirements and test methods Automotive fuels – Unleaded petrol – Requirements and test methods Paints and varnishes – Determination of stone-chip resistance of coatings – Part 1: Laboratory determination of chloride on cleaned surfaces corrected version ISO No part of this document may be transmitted or reproduced without prior permission of a Standards Department of the Volkswagen Group.
Spotting methods ISO NOTE 1 Rods with a length of mm and a diameter of 15 mm are suitable. Assessment of degree of delamination and corrosion around a scribe ISO General test methods v.
Clean off any dried residue of aqueous test liquids under running water, and clean off the dried residue of any other test liquids with a solvent that does not attack the coating. Determination of particle size distribution E Protective paint systems ISO The supplier must provide the following information for all parts to be tested: